Page 1 of 1

New with Estim 2b

Posted: Wed Dec 19, 2018 11:47 am
by feetinflips
I have purchased the Estim 2b device and started experimenting with the device. I' ve used 2 conductive rubber loops which where placed under my cock glans and at the base of my shaft. I've connected the lead as follows: on Channel A, red lead on the top loop and the black lead on the bottom loop.

The device was tested both of battery and also on with the power supplied. On both occasions I have noticed that I was not feeling anything between 1% and 50%. When connected through the power supply ove 50%, a good feeling was achieved but below that percentage there was no stimulation whatsoever.

Any advice please on how I could get the device to work on lower settings as well, please?

Thanks!

Re: New with Estim 2b

Posted: Wed Dec 19, 2018 2:53 pm
by Stimaddict
Hi feetinflips - I saw your message on Smartstim and it seems your CR loops are the problem as it does not happen when you use TENS pads.
You need to use conductive gel with your loops and make sure they are tight so they make better contact with your skin.

Re: New with Estim 2b

Posted: Wed Dec 19, 2018 3:25 pm
by feetinflips
Stimaddict wrote: Wed Dec 19, 2018 2:53 pm Hi feetinflips - I saw your message on Smartstim and it seems your CR loops are the problem as it does not happen when you use TENS pads.
You need to use conductive gel with your loops and make sure they are tight so they make better contact with your skin.
Apparently it happened with the TENS pads too from 1% up to 35% I felt nothing. That is quite weird for a machine which is not so cheap!

Re: New with Estim 2b

Posted: Thu Dec 20, 2018 7:23 am
by feetinflips
I've tested the TENS pads as well and they did not seem to work on low intensity either.

Any other advice will be greatly appreciated.

Thanks

Re: New with Estim 2b

Posted: Thu Dec 20, 2018 9:52 am
by admin
Not everyone is going to feel something at every level. Humans have a widely different range of sensitivity, so for some 35% is too much, for others its only the start. even at low levels its also dependant on the other settings at the moment, so the advice is experiment with positions of pads, and modes/levels.

Si

Re: New with Estim 2b

Posted: Thu Dec 20, 2018 2:10 pm
by Stimaddict
Try this...
  • Make sure you are using brand new TENS pads on clean skin. Don't use any lube or lotions.
  • Set your 2B to Hi-Power and plug in your mains adapter. Use only Channel A and select THROB mode.
  • Place one pad on top of your penis over or just below the glans.
    Hold it firmly in place with tape, straps or elastic bands.
  • Place the other pad behind your ball sack where it meets the perineum.
  • Slowly turn up the power on Channel A.
:?: At what level (on the LCD) do you start to feel sensation?

Re: New with Estim 2b

Posted: Thu Dec 20, 2018 2:13 pm
by Stimaddict
  • Now turn the power up until it feels about right.
:?: What level are you at now?

Re: New with Estim 2b

Posted: Fri Dec 21, 2018 11:07 am
by Majorityon
What programme are you using? I find that Pgm 1, which pulses, only starts to be felt at quite a high level. Try Throb mode.