Page 1 of 2

First impressions

Posted: Thu Aug 22, 2019 8:59 am
by nicoBS
Hi all,
I received the 2b box one week ago, and yet didn’t have any opportunity to test it at the best conditions. This might happen in the next few days.
For now I had only some occasions to try the box only a short time. I only used the elements delivered with the box (9V, patches) and no extra (which I ordered but didn’t received yet).

I can anyway tell about the very first impressions! Due to the bad conditions I was not able to be “hard”. I knew that was going to be complicate. The temperature was to warm, I wasn’t really relaxed, but I had to try.
I used only one channel, with 2 patches on it. One under the glan and one at the base of the penis. Since I was not in erection, the patches were almost touching each other -they look small on the photos but in reality they are quite big, 2 of them make almost 9 cm which is quite long for a penis without erection-.
Anyway I went forward, took care to avoid any contact between the patches. This did add a bit more stress to the already not relaxed situation. I plugged the 9V in the box, plugged all the needed cables where it had to go (which is not complicate at all) and switched on.
After few seconds, the screen finally shows the usual mode, letter A/B and so on. I have been reading few topics here so I decided to jump directly on throb mode, and slowly turned the A level.
From 10-12% I started to feel a small thing, that was new to me. The patches were good on place, but the penis had something like “what are you doing now”. After few seconds, I saw that it would been problematic to be at this non-erected condition, but I wanted to see forward. I moved the level up and up. I started to play with the modes. And from 25% it began to feel really strong! I barely could go over this amount (if I remember, I could go until 60% only on one mode). This was with 9V and I started to think, what the hell is this machine! I’m not yet on the half of the power with a 9V!
It felt quite picky, but still it was acceptable, I could feel the pleasure already and pre-cum came already. It felt quite “mechanical”, like somebody forcing you to have an orgasm at a moment when you absolutely don’t want it. I am sure that wouldn’t be an issue if I was erected and using conductive rubber loops. I had again another try in the same uncomfortable conditions but with the adaptor, with my penis that was a bit more erected but still was not enough.
For now I see the importance of having the right conditions: 1- room temperature. 2- position (bed, couch). 3- comfortable situation (need free time, I would say think about 3 hours of time to feel relax). 4- erected penis (with the 3 previous points and some entertainment that shouldn’t be an issue). 5- don’t panic with using 9V: it’s more than enough for a first try!. 6- consider cutting the patches. In my opinion they are to big.
That are my very first impressions! I hope this can help anyone thinking about purchasing the box.

Re: First impressions

Posted: Thu Aug 22, 2019 9:12 am
by mrbutt89
Hi nicoBS. Welcome to the forum and welcome to the 2B owners' club!
That was a really useful post to share with us. My first go with the 2B was similar to yours. I was desperate to get it out of the box and see how it felt. I only had a few minutes to play with it, but I connected a couple of loops to one channel, put the supplied audio CD in my personal CD player and tried some of the tracks. The excitement of it all made me hard before I even started putting the loops on my cock, so that was a help. Within 10 minutes I'd enjoyed my first hands-free orgasm, which certainly hadn't been my intention!
You make some very good points about how to enjoy a good session. You need to be relaxed to enjoy it to the full so, as you say, you need to allow time to settle into it, and you need to make sure you're physically comfortable, with a room temperature that's not too hot and not too cold.
There is a minimum recommended size for sticky pads. I can't remember what it is, but someone will know. If you do cut the pads down, make sure you make the corners rounded, not a sharp 90° angle, which will cause uncomfortable "hot spots".
I hope you enjoy your next session. It's one long voyage of discovery with e-stim.

Re: First impressions

Posted: Fri Aug 23, 2019 11:35 am
by Stimaddict
nicoBS> It is completely normal to feel anxious when you first start using your 2B. I remember my hands were shaking with my first try! But as you go on you will become more relaxed and comfortable with the unit until it all feels very natural.

For erections read this post: viewtopic.php?f=11&t=9956

Re: First impressions

Posted: Sun Aug 25, 2019 8:59 am
by Stimaddict
mrbutt89 wrote: Thu Aug 22, 2019 9:12 amThere is a minimum recommended size for sticky pads. I can't remember what it is, but someone will know.
Absolute smallest size is 1/2 x 3/4 of an inch, although personally I think it's best not to cut pads below one inch squared.

Re: First impressions

Posted: Sun Sep 08, 2019 10:55 pm
by nicoBS
I had my first HFO using the CL and patches on B channel. Throb mode , high power (on 9V) and 30 min were necessary but it feels damn good!!
Patch positionning is quite difficult. I had each patch on both side of the area between balls and anus, but again the distance between them was so small that I had a bit of stress, that they would or not touch each other. It was a very picky and strong stimulus on a very small area which is not what I was looking for, I’ll try next time to paste those things much more on the back or the side of the butt or inner side of the legs.
The CL: one just under glan and one under balls, very nice feel. Just it needs to regularly add the conductive gel, because when it’s drying the current doesn’t go through very well.

Re: First impressions

Posted: Tue Sep 10, 2019 12:19 am
by Justlearning1975
I bought the 2b about 6 weeks ago.... Used a homemade Davy box for a few years so not alien to estim.... Mainly with conductive rubber and pads but also bought an anal instable and a penis plug by estim with it but finding all this new world a bit scary....I guess I just need to relax ... Had one good session in the six weeks with the anal instable.. When I managed to get it in but can't get there penis plug instable in.... Went for the medium... Doesn't look that big but just can't get into my urethra and am scared to push it too hard... Anyone else had these problems

Re: First impressions

Posted: Tue Sep 10, 2019 7:36 pm
by nicoBS
I only had experience with urethral sounds, no electricity. Maybe you should buy a set of different sizes to “open”. My maximum diameter is 9mm at the moment. Now that I am into estim I stopped experiment the sounds but as I remember it is also a great (but different) pleasure.

Re: First impressions

Posted: Sat Sep 14, 2019 3:14 am
by Justlearning1975
How long did it take you to get to 9mm....I was going to try getting a sound but they looked so much longer and more scary which was why I decided to buy the plug as it looked shorter and am surprised that it just won't go in as it's not that wide.... Medium one which I think it is 8mm...I have sounded with a thermometer several times in the past which felt good and that was about 6mm ...Stupid and dangerous really but that went in easily... Not sure how much pressure I should apply to push it in and whether I should try to push it in before I start the electric stunning or do it whilst the electric still is going.... Any further advice would be appreciated

Re: First impressions

Posted: Sun Sep 15, 2019 12:33 pm
by electrofun
nicoBS wrote: Sun Sep 08, 2019 10:55 pm ... I had each patch on both side of the area between balls and anus, but again the distance between them was so small that I had a bit of stress, that they would or not touch each other. It was a very picky and strong stimulus on a very small area which is not what I was looking for...
One of the secrets for pleasant stim, for me at least, is to have some distance between the electrodes of the same circuit. Put them to close to each other, and it feels harsh very quickly.

Re: First impressions

Posted: Sat Oct 05, 2019 2:11 pm
by sbdx
One of my favorite setups is to cut two pads down to 3/8 of an inch wide by about 3/4 of an inch long, and place one on each side of the head, about half on the head and half on the shaft lengthwise. The feeling of the signals only focused on the head area and no where else can be incredibly pleasurable, or with the right signal can make you squirm from "torture".

If you or your partner are feeling a bit more sadistic, put on a plastic chastity cage over that setup and use a cage that is a fairly tight fit when flaccid so you can't even start to get much of an erection. You can eventually cum but it will drive you crazy getting there.