Hi
I want to extend my 2B Estim device with an internal Bluetoothe to RS232 interface. Which voltage level has the RS232 interface, 3.3V or 5V? Is there enough space inside the case to place the interface inside the 2B case?
Thanks
Internal Bluetoothe for the 2B
-
- Newbie
- Posts: 1
- Joined: Sun Jun 17, 2018 11:21 am
- Location: Zürich
-
- Newbie
- Posts: 3
- Joined: Mon Jan 01, 2018 5:28 am
- Location: NZ
Re: Internal Bluetoothe for the 2B
I would not look at trying to do anything internal.
1) Warranty
2) This cuts the external audio interface off. I am unsure what would happen if you disabled the commander mode but still used the audio input with serial data.
You would be better looking at makign a small interface box or better yet use the USB cable to a small PC.
I have mine hooked up to a Raspberry Pi Zero W. That lets me use software on there to control the 2B.
Have fun.
1) Warranty
2) This cuts the external audio interface off. I am unsure what would happen if you disabled the commander mode but still used the audio input with serial data.
You would be better looking at makign a small interface box or better yet use the USB cable to a small PC.
I have mine hooked up to a Raspberry Pi Zero W. That lets me use software on there to control the 2B.
Have fun.
-
- Active
- Posts: 15
- Joined: Thu Jul 27, 2017 9:15 am
- Location: Upper Austria
Re: Internal Bluetoothe for the 2B
Hi!
It works fine with the HC-05 Bluetooth-Board...
Look here, and see how I implemented it into the 2B:
viewtopic.php?f=19&t=8770#p12785
Cu
mills
It works fine with the HC-05 Bluetooth-Board...
Look here, and see how I implemented it into the 2B:
viewtopic.php?f=19&t=8770#p12785
Cu
mills