Help with uplink please

The most versatile and user friendly E-Stim control unit available today. If you want More Power, More Control, and more fun, then the 2B is the one you want.
Post Reply
stimmiestim
Newbie
Posts: 1
Joined: Sat Feb 18, 2023 1:32 pm
Location: Netherlands

Help with uplink please

Post by stimmiestim »

I'm trying to update my firmware of my newly purchased 2B, but all I get from uplink is "no response from 2B"

For the update I use windows 10 x64, installed CDM212364, did a reboot and I tried both Uplink 2.1 and 2.3. The e-stim 2B is powered via power adapter (no battery is inserted), powered on and connected to USB with the supplied cable that was in the Connect kit.

Any suggestions how to get it connected?

Thanks!


User avatar
admin
Site Admin
Posts: 2100
Joined: Tue Feb 19, 2008 8:14 pm
Location: Watford,UK
Contact:

Re: Help with uplink please

Post by admin »

Why did you install the drivers? Windows 10 normally does not need them.

Does you computer 'see' the USB port when the cable is connected?

Post a log?

Si
E-Stim Systems Ltd
ElectricJohnny
Active
Posts: 12
Joined: Thu Dec 16, 2021 4:59 pm
Location: Germany

Re: Help with uplink please

Post by ElectricJohnny »

I have the similar issue without having installed those drivers
(See my last post in the beta driver thread)
I assume that this behavior is due to the 2B is not in firmware update mode at that point in time.
Could someone please post a detailed update description?
User avatar
admin
Site Admin
Posts: 2100
Joined: Tue Feb 19, 2008 8:14 pm
Location: Watford,UK
Contact:

Re: Help with uplink please

Post by admin »

E-Stim Systems Ltd
ElectricJohnny
Active
Posts: 12
Joined: Thu Dec 16, 2021 4:59 pm
Location: Germany

Re: Help with uplink please

Post by ElectricJohnny »

Thank you very much!
This was what I was searching for.
User avatar
Zakal
Active
Posts: 46
Joined: Tue May 31, 2022 5:29 am
Location: Las Vegas, Nevada

Re: Help with uplink please

Post by Zakal »

Actually, I had the same issue. I had to disconnect and reconned my 2B several times before it was recognized, but then the update went smoothly.
"Hurt me!" said the masochist.
"No." said the sadist.
Post Reply