Simple Serial Port Tester

[admin]

One of the problems with modern computers is the lack of all the tools we sued to get. so we have now created a simple digital link tester. Simply copy the file to your desktop, extract it and then run it. You should then be able to connect to a serial port and send data to the Digital Link Interface.

If you don't see the correct serial port in the drop down, then you have not installed the drivers.

To test the digital link cable use a coin or metallic item to short the tip and the ring together. Then anything you 'Send' should show up on the screen. V will ask what version you are running (both for Commander and a 2B in bootloader mode), A10 will set channel A to level 10.

For the techies the serial port tester is set for 9600 8N1 with no local echo.

I'll get around to a little more manual writing for it soon.

Any issues or questions please post here!!!!

[aintnoway]

Does this support V2.126 ?

Thanks

[admin]

This doesn't require a 2B to be connected

Si

[samcdestim]

Perhaps the slight confusion is that when the ring and tip are linked anything you send will be looped back and displayed.

That test checked out the PC and serial link cable

The comment regarding sending V and displaying the version assumes the 2B is connected in boot mode instead of the short between ring and tip

Should work for all versions

If you do not get the version number displayed mean the 2B has not responded to the command, does happen quite frequently, keep trying, power 2B off and restart in boot mode etc.

Sam

[aintnoway]

...I was using lowercase letters, I am sorry for wasting your time

[estim_si]

...I was using lowercase letters, I am sorry for wasting your time

Asking questions is never a waste of time

Ask away

Si


Sent from my iPhone using Tapatalk