Hey all!
Just wondering if anyone has an idea of what the problem might be. I never used step mode, but tried it today to find I turn the output up and my conductive loops dont make any sensation. I only tried it on channel A, and havent tried with an insertable yet if that changes anything.
any suggestions or comments?
Thanks a ton!
JC
Step mode doesn't work
-
- Active
- Posts: 4
- Joined: Thu Jan 14, 2021 6:00 pm
- Location: In your basement
- admin
- Site Admin
- Posts: 2113
- Joined: Tue Feb 19, 2008 8:14 pm
- Location: Watford,UK
- Contact:
Re: Step mode doesn't work
Step mode is based on steps from 0% to whatever level you are at...so a low power level will give very small or non existent steps. If you are getting output in other modes, then step mode will work - turn it up!
Si
Si
E-Stim Systems Ltd
Re: Step mode doesn't work
Step mode doesn't work immediately. You need to wait above 20-30 sec.