www.e-stim.net

How can adjust the size of the intensity, I feel now the output power is too small for me

You can try using smaller electrodes to reduce the surface contact area, which will result in a perceived power increase. Or, if you are using the 2B use the mains power adaptor for an instant 30% increase in power.

In addition, if you're using a mode that creates pulses, you can slow the pulses down. This gives them more time to develop the power and it will feel more intense on each pulse.

mrbutt89 wrote: ↑Wed Feb 16, 2022 10:25 am In addition, if you're using a mode that creates pulses, you can slow the pulses down. This gives them more time to develop the power and it will feel more intense on each pulse.

A guy after my own tastes... love long hard pulses

To Shamo > Make sure you are using a new battery (or preferably the mains power supply adapter) for max available power.

I will, thank you very much

You could also try insertable electrodes. They tend to feel less spiky but have more intensity.

soundcraft wrote: ↑Sat Feb 19, 2022 12:07 pm You could also try insertable electrodes. They tend to feel less spiky but have more intensity.

My go to electrodes are:

Large magnum (bi polar and tri-phase)
75mm long x 8mm thick urethral sound.
Low profile 4mm cables.

This setup never fails and provides very good contact, no burns or stingy bits...
Good intensity too!

changing the settings whilst in a particular mode creates a range of different feelings (will usually refer to the 2B manual, e.g. at the top of page 8 of this version - https://e-stim.info/images/manuals/pdf/ ... Manual.pdf)
what mode(s) are you using? ...or what modes are you wanting to use at a higher intensity?