2b Working correctly?
Posted: Sun May 15, 2022 10:55 pm
Hello dear community,
I'm new to real e-stim and i just got my 2b with accessory pack two days ago. I was very happy with the 2b, settings and more and i loved how much power it has. But my second day experimenting i got an issue, which i will explain in the following.
I am not sure, if it works like it should or if i should contact the support. I need your experience with the device and settings.
First day:
I use the device in high power mode and use the E-Stim Systems Universal 110V/220V mains adaptor.
I experimented with the default Self Adhesive Electrode Pads and a conductive rubber loop. Depending on the location i could not go above 40% or 50% of the max. power. And sure, the rubber loops are not perfect but i used them well. Everything fine till the next "training day".
Today I tested the continuous and Puls mode again, but something changed:
- while turning the knobs the devices started to make kind of buzzing sounds if i go beyond 20/30%
- If i turn the knob to get more than about 50% power, nothing changes anymore depending on the electrodes. Using adhesive pads it changes minimally.. using rubber loops I don't feel any change.
I doubt that it should be like that? i had issues to get from 30-50% because the device is so powerful, but after the device makes buzzing noises now, it does not get much stronger than that.
I was even able to turn to 100% in continuous and pulse mode (not because i could stand that, but because it does not really get stronger?). So u can say the power turns up when turning the knob from 0 to 50% percent, but after that, the power stays almost the same.
Did you experience the same? should i contact the support or does it work near normally?
I really love the device <3 and would miss it.
Thanks in Advance!
2b or not to be! that is no question.
I'm new to real e-stim and i just got my 2b with accessory pack two days ago. I was very happy with the 2b, settings and more and i loved how much power it has. But my second day experimenting i got an issue, which i will explain in the following.
I am not sure, if it works like it should or if i should contact the support. I need your experience with the device and settings.
First day:
I use the device in high power mode and use the E-Stim Systems Universal 110V/220V mains adaptor.
I experimented with the default Self Adhesive Electrode Pads and a conductive rubber loop. Depending on the location i could not go above 40% or 50% of the max. power. And sure, the rubber loops are not perfect but i used them well. Everything fine till the next "training day".
Today I tested the continuous and Puls mode again, but something changed:
- while turning the knobs the devices started to make kind of buzzing sounds if i go beyond 20/30%
- If i turn the knob to get more than about 50% power, nothing changes anymore depending on the electrodes. Using adhesive pads it changes minimally.. using rubber loops I don't feel any change.
I doubt that it should be like that? i had issues to get from 30-50% because the device is so powerful, but after the device makes buzzing noises now, it does not get much stronger than that.
I was even able to turn to 100% in continuous and pulse mode (not because i could stand that, but because it does not really get stronger?). So u can say the power turns up when turning the knob from 0 to 50% percent, but after that, the power stays almost the same.
Did you experience the same? should i contact the support or does it work near normally?
I really love the device <3 and would miss it.
Thanks in Advance!
2b or not to be! that is no question.