www.e-stim.net

Hello to all dear stimer
could you share your best settings and parameters for a fast ejaculation and a strong hard-on

I just got in the biphasic and triphasic cables so this will change I believe with use of it but with regular cables I use two cables to flange and then put rubber loop at head and one wrapped around cock and balls. Pulse for a bit the switch it to throb and turn adjustment knob up to 75 and get a good throb on your prostate and as that swells and prostate starts to contract then turn up cock loops!! Happy stimming

Very thanks for your sharing

Throb mode, 1 channel, 2 rings..... works every time!

Flyy wrote: ↑Mon Oct 31, 2022 8:06 pm Throb mode, 1 channel, 2 rings..... works every time!

Haha! So true!! Simple two ring works!!

What sort of levels and feel control settings (where applicable) are you guys using for the various modes (assuming that you are using the AC power supply)?

I don’t need, or even want an erection when I shoot. A limpy fatty drooling a load is beautiful.

Try this from Stimaddict. Works a treat

viewtopic.php?p=17500#p17500

@flyy:

Where do you place the rings and what settings do you use and hi or lo power

Regards,
Willy

Common prostate, A sticky pad on the head and B sticky pad on the top of the shaft close to the root. Anything high power in this configuration usually gets me going quick. I think it’s the optimal mix of hitting both nerves and sending everything through the prostate.