Pulse Mode of 2B much weaker than Pebble?
Posted: Thu Dec 29, 2022 6:43 pm
Hi folks,
1st time posting - what an amazing community, thank you!
I have had the Pebble for two years now and I used it almost exclusively with my Stuffer Bipolar Butt Plug.
The Pebble Pulse mode feels quite good and delivers a nice ghost fucking experience for most of the time, I can't max out the power but when it gets intense, then I desire more than it can provide. Therefore I just bought a 2B, assuming it will deliver the same pulse mode feel but with more power as the Stuffer requires a lot of juice. Last night I tested it for the 1st time and was disappointed.
I can easily max out Pulse mode on H setting at 100% Power and with the feel settings anywhere from 10 to 100. When maxed out it feels like 50% on the Pebble. I switched the electrodes back an forth between both boxes, therefore I can rule out pad placement, etc. Also the signal seems less "crisp" than the Pebble. The Pebble delivers a clean, crisp pulse, while the 2B signal feels more "muddled".
I just emailed e-stim systems and they stated that this is normal and everybody experiences it differently. I just have a hard time accepting, that the 2B Pulse mode is so weak. Also other 2B modes needed much higher power settings than expected.
Questions:
Has anybody experienced this too?
Could the box be faulty?
I also tried a couple of wave files as suggested by Stimaddict here on the forum: Mr. Terminator Pulsinator Suite and from V91 with mixed results. Some files delivered more power while others were inconsistent. I haven't found a file that delivers the Pebble Pulse feel. However, I don't have enough experience yet to judge this. Any suggestions welcome.
Sorry for the lengthy post, and thanks in advance.
Happy Holidays!
1st time posting - what an amazing community, thank you!
I have had the Pebble for two years now and I used it almost exclusively with my Stuffer Bipolar Butt Plug.
The Pebble Pulse mode feels quite good and delivers a nice ghost fucking experience for most of the time, I can't max out the power but when it gets intense, then I desire more than it can provide. Therefore I just bought a 2B, assuming it will deliver the same pulse mode feel but with more power as the Stuffer requires a lot of juice. Last night I tested it for the 1st time and was disappointed.
I can easily max out Pulse mode on H setting at 100% Power and with the feel settings anywhere from 10 to 100. When maxed out it feels like 50% on the Pebble. I switched the electrodes back an forth between both boxes, therefore I can rule out pad placement, etc. Also the signal seems less "crisp" than the Pebble. The Pebble delivers a clean, crisp pulse, while the 2B signal feels more "muddled".
I just emailed e-stim systems and they stated that this is normal and everybody experiences it differently. I just have a hard time accepting, that the 2B Pulse mode is so weak. Also other 2B modes needed much higher power settings than expected.
Questions:
Has anybody experienced this too?
Could the box be faulty?
I also tried a couple of wave files as suggested by Stimaddict here on the forum: Mr. Terminator Pulsinator Suite and from V91 with mixed results. Some files delivered more power while others were inconsistent. I haven't found a file that delivers the Pebble Pulse feel. However, I don't have enough experience yet to judge this. Any suggestions welcome.
Sorry for the lengthy post, and thanks in advance.
Happy Holidays!