Hi all,
Today I stumbled on this new box. Apparently an improved 2023 (micro) version of the ET-312B. Quite pricy. Looks interesting though.
Any thoughts on this, reviews or 'first hand' experiences?
Happy stimming!
Korsakovski
Enfettered E-stim Micro312 Power Box
-
- Active
- Posts: 8
- Joined: Thu Nov 05, 2020 10:40 am
- Location: Netherlands
- estim_si
- Staff
- Posts: 386
- Joined: Tue Feb 19, 2008 11:23 pm
- Location: Watford
- Contact:
Enfettered E-stim Micro312 Power Box
Apart from the fact it’s not actually made by Erostek, it’s a literal rip off of the ET312 design. And they don’t have access to the firmware they are just flashing the original code.Korsakovski wrote:Hi all,
Today I stumbled on this new box. Apparently an improved 2023 (micro) version of the ET-312B. Quite pricy. Looks interesting though.
Any thoughts on this, reviews or 'first hand' experiences?
Happy stimming!
Korsakovski
Sent from my iPhone using Tapatalk
-
- Active
- Posts: 9
- Joined: Sun Mar 20, 2022 3:10 pm
- Location: Paris
Re: Enfettered E-stim Micro312 Power Box
The problem with the ET312 clones many commercial or home-made boxes is they copied the bugs as well.
There are a lot:
Wrong sound (audio-3) interpretation: As many boxes, the zero crossing is detected to trigger a pulse and a capacitor detects the amplitude for the pulse amplitude. Of course there is a resistor to (slowly) discharge. The time constant is around 100mS that kills all the fast stroking sensations. I changed 2 capacitors to decrease down to 15mS. That introduces a minimum base frequency around 200Hz
Unexpected result: the zero crossing is detected by a comparator. There is 2 for the 2 channels. However, there is no input resistors that can make unexpected results as there are always protection diodes between the + and the - input.
Battery killing ... for a lot of assemblies: The floating voltage for AGM batteries is 13.60. They used 14.2 because of a diode after the regulator. When the battery is charged, the voltage on the diode is close to 0. This schematics is mainly used in security alarms, but they are never shut down.
BK2: They didn't consider the output voltage tolerance on the regulator.
BK3: They would have use smaller regulator divider resistors bridge as there is a minimum load for proper regulation and one of these resistor is a 5% tolerance.
Perhaps more bugs I haven't yet found.
There are a lot:
Wrong sound (audio-3) interpretation: As many boxes, the zero crossing is detected to trigger a pulse and a capacitor detects the amplitude for the pulse amplitude. Of course there is a resistor to (slowly) discharge. The time constant is around 100mS that kills all the fast stroking sensations. I changed 2 capacitors to decrease down to 15mS. That introduces a minimum base frequency around 200Hz
Unexpected result: the zero crossing is detected by a comparator. There is 2 for the 2 channels. However, there is no input resistors that can make unexpected results as there are always protection diodes between the + and the - input.
Battery killing ... for a lot of assemblies: The floating voltage for AGM batteries is 13.60. They used 14.2 because of a diode after the regulator. When the battery is charged, the voltage on the diode is close to 0. This schematics is mainly used in security alarms, but they are never shut down.
BK2: They didn't consider the output voltage tolerance on the regulator.
BK3: They would have use smaller regulator divider resistors bridge as there is a minimum load for proper regulation and one of these resistor is a 5% tolerance.
Perhaps more bugs I haven't yet found.