Hello,
I have two questions regarding the audio inputs (mic and line in)
1) The stereo mode is working, but the display is flickering all the time. Is this normal?
2) The microphone mode is a little bit strange for me. The sound must be really loud (even with x4 sensitvity) to get a higher level.... Also, when there is absolute silence, the outputs are on, not to strong but continuous. On the E-Stim Remote the mic behavior is much more than expected.
Is this normal?
Thanks
Microphone and Stereo mode
-
- Newbie
- Posts: 1
- Joined: Sun Dec 10, 2023 7:18 am
- Location: Germany
- admin
- Site Admin
- Posts: 2168
- Joined: Tue Feb 19, 2008 8:14 pm
- Location: Watford,UK
- Contact:
Re: Microphone and Stereo mode
Yes. It is down to the amount of processing the 2B is running when in audio mode
Generally yes, although the response is highly depending on the acyual sound. amplifiers also pick up low level base noise which is why generally in microphone mode there is some backgorund noise picked up.2) The microphone mode is a little bit strange for me. The sound must be really loud (even with x4 sensitvity) to get a higher level.... Also, when there is absolute silence, the outputs are on, not to strong but continuous. On the E-Stim Remote the mic behavior is much more than expected.
Is this normal?
Si
E-Stim Systems Ltd
-
- Active Developer
- Posts: 573
- Joined: Wed Feb 23, 2011 11:06 am
- Location: Rayleigh, Essex, UK
Re: Microphone and Stereo mode
As Admin has said, some degree of flickering is normal. But sometimes it can be caused by the volume level on your source being too high. Ideally the levels shown by the bars on each channel should generally be 75% or less. Feed a louder signal to the box and you'll lose some of the detail. It's worth taking the time to find the best balance between the input signal and the levels selected on the A and B knobs.
-
- Active
- Posts: 4
- Joined: Sat Jun 18, 2022 7:18 am
- Location: Italy
Re: Microphone and Stereo mode
I have a problem of this type: in stereo mode with the audio cable connected to the PC the Estim commands go crazy, they are not manageable, to be able to select the mode I have to disconnect the cable and reinsert it, furthermore the adjust command works very badly, all of this is normal ?
- admin
- Site Admin
- Posts: 2168
- Joined: Tue Feb 19, 2008 8:14 pm
- Location: Watford,UK
- Contact:
Re: Microphone and Stereo mode
sounds like you are massively over driving the audio levels....try dropping them downRobby14 wrote: ↑Wed Jan 31, 2024 8:18 am I have a problem of this type: in stereo mode with the audio cable connected to the PC the Estim commands go crazy, they are not manageable, to be able to select the mode I have to disconnect the cable and reinsert it, furthermore the adjust command works very badly, all of this is normal ?
Admin
E-Stim Systems Ltd