www.e-stim.net

Hi
Not new to estim - have manged to achieve hands free orgasm but struggle getting / maintaining erection until almost point of orgasm - am I doing something wrong or is that 'normal'?
Thanks for any insights

Perfectly normal from what I understand. I am the same, as are many, best I can achieve is a semi when I'm near to the HFO

From my limited experience (started e-stim 2019) & at 81, I can only try to remember how I was, 60 years ago. Some days I was walking around with a seemingly permanently hard on. frequent wanking needed! Now I have on prescription Tadalafil 10mg & within about an hour, with stimulus I get a semi. As a widower E-Stim is a godsend, so I stim once or twice a week. The only way I can recreate my past glory, is to vacuum pump, remove & tie (10mm restrain rope) around balls & cock very tight. Continue to stim & I am rock hard once again. I do not cum with this technique but just enjoy feeling/looking at the old chap.

in late 40's...
For me, Anal and or electric stimulation doesn't cause and even will make me lose erection. A c-ring slows the process, but even then, gone after a minute or so with anal penetration and not much longer with e-stim... There is one setting with the 2B that forces an erection as hard as I've ever had in life (and harder than any since my 20's): continuous with adjust at 27 or 28. A metal ring around glans and the other electrode being just about anything so far (base and head of moaner and flo all work, as well as shaft or c-ring).

I figure machines and bodies all different, but the setting for me feels like a smooth buzzing/ squeezing pressure vibration has a repeating cycle, but sensation also seems to move or roll between electrode locations. Other settings, for me, don't have the sense of internal motion for the stimulation. I don't know if there a connection between how my nerves respond to the signal creating the perceived movement of sensation and the forced erections (I only have 1 data point, lol), but it's the only occurrence of each for me so far and has been consistent (knock wood). Maybe look for a signal/ setting that, on a single channel seems to roll around/ between electrodes?


2B, firmware 2.106, Plugged into US electric grid
Settings: High power, continuous: adjust: 27 or 28
electrodes: 30mm electro ring at glans paired with anything tried so far on channel B (35mm electro ring on shaft, 45mm electro ring base, either electrode of inserted flo or moaner tested)

I have posted, previously, my opinion regarding erection issues & have attached a photo of my technique. Remember, I now live alone, so penetrative sex is not required. However, who doesn't like to see a good hard one, even if its just for show.
The pink restrain rope (10mm) is placed around my balls & cock & well lubed, but not tied. Introduce the vacuum pump & pump for a while until I think I am as erect as possible. Quickly remove vac wrapping twice around & firmly tie. This illustration I am using a Tri-Phase cable, common (black) to centre of large Deviant. A pad on the perineum & a smaller 40mm one on my cock completes the circuit. You can see I am on A-Split, lots of fun can now be had. My cock gets rock hard as I continue to stim & as no blood can return also turns purple as does my balls!
Of course I do not wish it to fall off!! Ha. So tend to release after maybe 15 minutes or so. What does everyone think?

Hi Everyone
Further to my previous post with photo, here is another angle of my way of temporarily holding a good hard during play. To be honest it is sort of fake, by that I mean, it is my wonderful cock but to get to this requires much vacuum pumping & restriction around cock & balls with my pink rope as shown. You can see in the mirror I have an Oxballs ball stretcher in place. I sometimes add more rings to this for a really hard stretch, or my Stainless Steel weighted ones.
For Stim just using the little Helix connected to either a pad on the Perineum (always) or to one of my anal toys like the Large Deviant & as shown underside of my cock. Of course I vary the position of both pads. later in my session, I would fire up the 2-B & as I have three points, connect with Tri-Phase. Wonderful!