www.e-stim.net

Hi all,

I just installed the new firmware 2.106 and i did noticed a different system modes layout:

V2.105_______vs______V2.106
1. Pulse_________________1. Pulse
2. Bounce_______________2. Bounce
3. Continuous____________3. Continuous
4. A Split _______________4. A Split
5. B Split________________5. B Split
6. Wave_________________6. Wave
7. Waterfall______________7. Waterfall
8. Squeeze______________8. Squeeze
9. Milk_________________9. Milk
10. Throb______________10. Throb
11. Thrust______________11. Thrust
12. Random____________12. Random
13. Step_______________13. Step
14. Training____________14. Training
15. Microphone_________15. Microphone
16. Stereo_____________16. Stereo
17. Tickle______________17. Tickle

18. Power Level_________18. Power Level
19. AB Join_____________19. Mic Level
20. Backlight___________20. A&B Chan link
21. Factory Reset_______21. Backlight
22. Commander________22. Full Reset


as you can see, "mic level" is added, and the rest of the modes moved down a place (AB join changed into A&B Chan link, Factory Reset changed into Full reset).
But the Commander modes disappeared.
Thoes this mean you no longer need to manually configurate the 2B to commander modes if you want to control it by PC???

That is correct, it is actually mentioned on the download page

https://store.e-stim.co.uk/index.php?ma ... ucts_id=41

2.106

Commander is now automatically switched on and off when required

Improved Microphone mode, together with selectable Microphone sensitivity (selected via Microphone level to x1 x2 and x4.) The microphone mode also now has a built in 'noise gate' so allowing you to set a value where ambilent sounds or noise gives no response.

Slightly smoother feel

Hope that helps

Si