Hello, got my 2B today, but...
Posted: Fri May 25, 2018 2:43 pm
Although it seems to work well, I was somewhat alarmed when unwrapped it from the shrink-wrap plastic after I took it out of the plastic carrying case, and a screw fell out!
Upon further examination it's one of the 4 back-case corner screws, and I can clearly see where it's supposed to go but I find that I cannot screw the screw in.
I haven't disassembled it, but it appears that there is no hole into which the long thin screw can be screwed into. It just spins in place when I apply pressure to screw it in using my small phillips screwdriver.
I can't imagine it is to be expected, nor do I imagine that the other three screws aren't enough to keep the two halves of the 2B's case closed, it's just a little weird that for a unit as expensive as this, I would find such an easy to find defect...
Hopefully using it will turn my frown upside down.
Upon further examination it's one of the 4 back-case corner screws, and I can clearly see where it's supposed to go but I find that I cannot screw the screw in.
I haven't disassembled it, but it appears that there is no hole into which the long thin screw can be screwed into. It just spins in place when I apply pressure to screw it in using my small phillips screwdriver.
I can't imagine it is to be expected, nor do I imagine that the other three screws aren't enough to keep the two halves of the 2B's case closed, it's just a little weird that for a unit as expensive as this, I would find such an easy to find defect...
Hopefully using it will turn my frown upside down.