New guy with home made urethral electro sound..
Posted: Thu May 31, 2018 12:21 am
Hey everyone.. New here.
Iv never had allot of luck (falling out and flapping around) and always pain afterwards when using urethral electro sounds, so I went ahead a built what I wanted. It looks like the Vibrating Bullet Urethral Insert except it operates like the Folsom Stainless urethral Insert. But imagine pushing the Folsom Insert in past the non-rounded end? Ouch..! Not only that, but the heavy banana connector inch's from your penis would be flapping all over the place when playing, tugging on your pee hole! Double ouch!
So anyway, my insert is a Stainless 1"x 1/4" plug rounded nicely on both ends with a 1/32" hole drilled in one end and polished to a 1000 grit finish. I built it with my lathe, and all I can think is wow.. Why haven't I done this sooner! I soldered the small 28 awg wire, which is the folsom supplied wire which plugs into the psg202, directly into my SS insert with high silver solder then cleaned and let it soak in everclear. I put the warmed folsom Single-Pole Anal Insert in, and slide my shortened fleshlight over my penis. I then slide my urethral insert into my penis with no lube. Its smaller diameter, super smooth rounded shape slid right down easily.. And more importantly, stayed where I put it while I played. What's so cool about it, is how easily it can be slide as far as your dare and how the sensations change and increase as your pulling it out. I literally had the two inserts inch's from one another and then slowly pulled it to my head while stroking with a flesh light and astroglide.. No pain during or afterwards the way its supposed to be! But I'm not so daring anymore and keep the insert in the head just in case the wire comes loose..
Anyway, just had to share this as I cant get enough of this setup, unlike the expensive painful urethral inserts Iv tried in the past.
Cheers!
Iv never had allot of luck (falling out and flapping around) and always pain afterwards when using urethral electro sounds, so I went ahead a built what I wanted. It looks like the Vibrating Bullet Urethral Insert except it operates like the Folsom Stainless urethral Insert. But imagine pushing the Folsom Insert in past the non-rounded end? Ouch..! Not only that, but the heavy banana connector inch's from your penis would be flapping all over the place when playing, tugging on your pee hole! Double ouch!
So anyway, my insert is a Stainless 1"x 1/4" plug rounded nicely on both ends with a 1/32" hole drilled in one end and polished to a 1000 grit finish. I built it with my lathe, and all I can think is wow.. Why haven't I done this sooner! I soldered the small 28 awg wire, which is the folsom supplied wire which plugs into the psg202, directly into my SS insert with high silver solder then cleaned and let it soak in everclear. I put the warmed folsom Single-Pole Anal Insert in, and slide my shortened fleshlight over my penis. I then slide my urethral insert into my penis with no lube. Its smaller diameter, super smooth rounded shape slid right down easily.. And more importantly, stayed where I put it while I played. What's so cool about it, is how easily it can be slide as far as your dare and how the sensations change and increase as your pulling it out. I literally had the two inserts inch's from one another and then slowly pulled it to my head while stroking with a flesh light and astroglide.. No pain during or afterwards the way its supposed to be! But I'm not so daring anymore and keep the insert in the head just in case the wire comes loose..
Anyway, just had to share this as I cant get enough of this setup, unlike the expensive painful urethral inserts Iv tried in the past.
Cheers!