www.e-stim.net

Hi,
Just got my new 2B and I am wondering if it is possible to store the power level settings from the "power selection". So that it always starts with high when the 2B is switched on.

It's in the current beta.

Si

It would also be useful if, after setting the power level, the box went back to the setting it had been on (e.g. stereo), rather than reverting to the default pulse.

I also would like this setting to stay the same. I have a favorite mode. I would love to just switch on and it go to that mode and feel adjustments. That would be awesome.

And that too is in the current Beta

Si

I am on the current beta but when I restart it the settings are not saved. The mode is. but the feel settings are not. Am I doing something wrong?

Yup Feel and Timing values (We call them the C and D values) are not currently saved even in the latest Beta. We looked at it, but we have found that there are a number of issues.

Si

Ok ... Thanks for the update

Still love the 2B.. And updates just make it better every time...

I timed my initial 2B setup today using v2.106...

>>> Switch on select Hi-Power select 'Throb' mode adjust to 65 begin stimming

Took exactly 28 seconds. Not a deal breaker for me.

28 seconds isn't a deal breaker, but it is annoying. I've had my unit reset a few times mid session in high power mode (plugged in to mains with official hardware). And that time is an eternity when you're a good way into a session.